Creda E430E User's Guide download pdf

IMPORTANT WARNINGS!

DO NOT SWITCH THE APPLIANCE ON IF YOU SUSPECT IT OF BEING FROZEN.

WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT.

DO NOT OPERATE THE APPLIANCE IF WATER DISCHARGES FROM THE PRESSURE RELIEF

VALVE. MAINTENANCE IS REQUIRED BEFORE THE APPLIANCE CAN BE SAFELY USED.

THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN AND

THE INFIRM) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES,

OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN

SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE

BY A PERSON RESPONSIBLE FOR THEIR SAFETY.

CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY

DO NOT PLAY WITH THE APPLIANCE.

1. Ensure the electricity and water are turned on to the unit.

2. Press the start / stop button “B”.

This will turn the shower on, the water will flow and the

area around the control knobs and button will illuminate.

It is recommended that you do not wholly enter

the water flow during this period.

3. Knob “A” controls the power selection.

Select High (2 red bands), Medium (1 red band) or

Cold (1 white band).

The pointer on the knob indicates setting.

4. If the water is not at your desired showering

temperature, turn knob “C” a small amount

until you reach the desired showering temperature.

Turn clockwise towards the white bands for cooler.

Turn anti-clockwise towards the red bands for warmer.

5. When you have finished showering,

press the start / stop button “B” again.

The illuminated areas will go out.

10.5kW Models Only-Water will continue to flow for approximately 7 seconds before switching off

6. Switch off the electricity supply at the ceiling switch or local isolator.

Notes

• Wait 20 seconds for the temperature to stabilise after each adjustment.

• If the shower has been recently used, it may take up to 20 seconds to come on

During this time the water may go from very hot to cold before stabilising.

• The position of knob “C” will be approximately the same each time the shower is used,

varying only with incoming water temperature or pressure changes

(e.g. you will only need to change from summer to winter).

• During normal operation, if an overheated water temperature is sensed then the heater

will switch off.

Water will continue to flow and cool down before the heater switches back on again.

We offer a technical advisory service on the telephone to installers and

other customers with problems in the field. RING 0844 372 7766 (UK ONLY)

(A3) Leaflet No. 567-2277-03a

HOW TO USE YOUR AquaNoir SHOWER (SUMMARY)

IMPORTANT:

This booklet should be left with the user

after installation and demonstration

AquaNoir Range

ELECTRIC SHOWERS

Installation and User Guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Installation and User Guide

16 IMPORTANT WARNINGS! DO NOT SWITCH THE APPLIANCE ON IF YOU SUSPECT IT OF BEING FROZEN. WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT. DO NOT OPERATE

Page 2

Page 3 - IMPORTANT SAFETY INFORMATION

14 1. Water is heated instantaneously as it flows over the heating elements in the copper cylinder (Diagram 9). 2. The heaters are only switche

Page 4

4 WARNING: ALL WIRING AND INSTALLATION MUST BE SUPERVISED BY A SUITABLY QUALIFIED PERSON. WARNING: DO NOT INSTALL THIS SHOWER WHERE IT MAY BE

Page 5 - RING 0844 372 7750 (UK ONLY)

12 CREDA AFTER SALES SERVICE

Page 6

6 Please note that standard compression fittings are shown. Push-Fit connections or a combination of the two is also suitable. To aid installati

Page 7

10 IF WATER IS TOO COLD Turn knob “C” anti-clockwise to 11 o’clock and continue turning anti-clockwise until you get the water temperature of your

Page 8 - ASSEMBLY OF ACCESSORIES

8 5. Re-fit the detachable bottom section with the two screws if it was removed. 6. Locate and connect the front cover power supply cable as shown

Comments to this Manuals

No comments

Creda E430E User's Guide

Browse online or download User's Guide for Ovens Creda E430E. Creda E430E User guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Ovens Creda E430E