Creda Single Oven User Manual download pdf (Page 33)

Before calling a Service Engineer, please check through the following lists.

THERE MAY BE NOTHING WRONG.

SOMETHING WRONG?

Problem

Nothing works.

Display shows 0.00 AUTO.

Timer display shows " Auto " lit up

or flashing.

Timer display correct but

appliance will not operate

Can not set an “Auto Cook”

programme

Draught from beneath control

panel.

Cooling fan not operating

Oven burner not working

Slight smell of gas after closing

oven door.

Oven appears to be cooking at too

high a temperature.

Timer buzzer/bleeper operates

continually

Check

If the timer display is blank.

Then it is likely that there is no electricity supply to your oven.

Check: (i) That the main cooker wall switch is turned on.

(ii) Check other appliances to see if you have a power

cut.

(iii) Check the main circuit breaker for the property.

The power supply to your oven has possibly been interrupted, but has

now come back on again. Reset the timer to the correct time of day and

"Manual" operation using instructions given in the timer section of the

book.

To use the ovens or grill the timer must be set to manual mode. See timer

instructions.

The appliance incorporates a safety device to shut down the burners in

the event of a fault, to prevent overheating.

In this case contact your service engineer to have the fault rectified and

the safety device reset.

Remember that " Cook period " is the actual length of time for which

the timer will switch the oven(s) on as part of an "Auto cooking "

programme.

A gentle flow of air will be blown from beneath the control panel when

the appliance is used. If the appliance is still warm, this cooling fan may

continue to run, or restart itself after all controls have been turned off.

The fan will stop once the appliance has cooled.

If no air is blown from below the control panel when the controls are

switched on and you have checked through the " Nothing works "

section above, then the cooling fan may be faulty. In this case you

should turn off the appliance and contact your service agent to arrange

for a repair.

Note that the oven burners only operate when the door is closed to

ensure safe operation and avoid wasting heat. With the door closed the

oven burner will ignite.

This is due to the short delay while the burner reignites and will soon

disperse.

It may be necessary to turn to a lower setting than shown on the cook-

ing chart or recipe as results depend on personal tastes.

If the oven appears to be cooking at too high a temperature than

previously, and turning down the thermostat has no effect, then the

thermostat may be faulty and you should contact your service agent.

Buzzer / bleeper should stop automatically after two minutes. If not.

press minute minder button to silence.

If you have been through the above list and there is still a problem;

Contact Service (see Key Contacts, back page).

1 2 ... 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Creda Single Oven User Manual Page 33

Comments to this Manuals

Related products and manuals for Kiln Creda Single Oven